Domino Ax Series, User Documentation

Page: 14 / 167

HEALTH AND SAFETY
1-4 EPT019297 Issue 1 November 2016
INKS AND FLUIDS INFORMATION
Domino supplies Safety Data Sheets (SDS) giving specific safety information with each of its ink,
make-up and wash fluids. There are also warnings on each container. The following are general
basic requirements:
WARNING: Do not install or operate the printer in closed or sealed rooms or
cabinets. The printer must be installed and operated in a well
ventilated environment. Insufficient ventilation may result in an
accumulation of vapour which can present a risk of explosion.
Basic Requirements
When used correctly, printing inks do not cause problems. However, everybody using them
should be familiar with the appropriate safety standards and be aware of the precautions that
should be taken. The following are basic requirements:
• Proper standards of industrial practice relating to cleanliness and tidiness must be
maintained.
• Inks and their containers must be stored and handled with care.
• Do not smoke or allow naked flames (or other sources of ignition) in the vicinity of any inks or
solvents as this is highly dangerous.
• All who come into contact with inks must be properly instructed in their use.
Directions for safe working practices vary according to the environment. The following are broad
principles so that necessary precautions may be taken:
• Contact with the mouth must be avoided. Therefore eating, drinking or smoking, or any
personal habits or actions which may transfer ink to the mouth, must be avoided.
• Contact with the eyes must be avoided. Suitable eye protection must always be worn
whenever there is any risk of splashing or misting. If ink does get into the eyes, first aid
treatment is to flood the affected eye for 15 minutes with saline solution, (or clean water if
saline solution is not available), taking care not to allow the water to run into an unaffected
eye. Medical aid must be obtained immediately.
• Most inks contain solvents which may injure the skin. Good working practice must always be
employed and risk assessments carried out. Safety Data Sheets are available that give
advice on personal protective equipment. Most gloves only offer limited and short term
exposure protection and must be changed after any splashing and on a frequent basis.
• Many inks contain materials which vaporise easily and can be inhaled. Good ventilation is
necessary.
• Any used cleaning materials, e.g. rags, paper wipes, are a potential fire hazard. They must be
collected for safe disposal after use. After exposure to ink, all possible traces must be
washed off as soon as possible at the nearest washing facility.
• It is possible to control the printer remotely. If operated in this manner it is vital that the
remote UI is disconnected before carrying out any cleaning or maintenance on the printer.
Storage
Printing inks must be stored in well ventilated buildings, in areas set aside for the purpose and
chosen for safety in case of fire. All fluids must be stored in accordance with local regulations.