EN
Safety instructions
SMP301
12
A
NOTICE!
•
Make sure the ventilation grills in the product are not covered.
•
Ensure good ventilation.
2.4
Operating the battery charger safely
(only SMP301-07)
D
DANGER!
•
The battery may emit explosive gases during the charging process.
Ensure that there are no sparks or flames in the vicinity of the battery.
Ensure that the product is sufficiently ventilated.
!
WARNING!
•
Wear safety glasses when handling the battery and especially when
connecting and disconnecting the battery.
•
In the event of the skin or eyes coming into contact with battery acid,
rinse out the affected areas immediately with lots of water and call a
doctor.
•
Only charge rechargeable batteries.
•
Only charge the battery if it is not frozen.
•
Do not put the battery charger on the battery.
•
Do not cover the battery charger.
•
Only use the battery charger if the casing, connections and cable are
undamaged.
A
NOTICE!
•
A charging voltage of up to 15 V is possible during the charging pro-
cess. Ensure that there are no consumer units connected to the battery
during the charging process. This is to prevent the consumer units
connected from being damaged.
•
The battery charger switches to preservation mode following the
charging process. If the battery charger does not switch out of charge
mode, disconnect the battery charger from the battery. Have the bat-
tery charger checked by a specialist electrician.
•
Regularly check the battery for damage and for defects when it is in
use. A defective battery is detected by the battery charger during the
charging process.
SMP301-01-02-03-04-05-10--IO-7s.book Seite 12 Mittwoch, 23. Oktober 2019 11:56 11
