27
3.1.2. Replacing heater element (”Half-moon” shaped)
- Unscrew hinge screw on boiler side, slightly bend out side wall of hinge.
(Figure 99)
- Remove temperature controller from boiler
(see 2.3.4).
- Bend out tabs of boiler casing.
(Figure 100)
- Remove
cover.
(Figure 101)
- Slightly push up boiler insulation, remove
(see 2.3.3).
- Mark securing position of the heating element on the boiler to help
reassembly. (marker)
- Push down clamp securing element wire.
(Figure 102)
- Rotate back heater element in the direction of back panel.
(Figure 103)
- Push down securing clamp of heater element using 2 universal pliers.
(Figure 104)
- Reinsert the heating element. Electronically, this operation is identical to
those described for cylindrical element
(see 2.3.3).
-
Attention!
The capacity of a heating element with ”fuzzy logic” control is
different from those with electromechanical control!
-
Placing of the heating element. Place securing clamp in the middle of the
element.
Place upper edge of heating element at the marking of position.
Figure 99
Figure 100
Figure 101
Figure 102
Figure 103
Figure 104
