9. Alarm function
Speed dome may connect with 4 alarm input, 1 alarm output, and support
alarm linkage. The external alarm message sends to the dome, then the dome
sends to alarm point shoot (to call preset, auto scan, auto cruise and auto pattern),
and choose that to run alarm output or not.
The system enters into the main menu by calling 95 preset or by calling 9
preset twice within 3 seconds. click each menu according to the left picture,
then enter menu alarm, choices as follow:
alarm number is corresponding with 7 bits
plug in the external switching board of the dome(as below shows).
as current alarm input, to run the action.
Choices for choosing as follow. NONE---none action/SCAN/PAT X---run a
pattern tour /TOUR---run tour/PRESET---call preset, when the dome number
is set as 1, to call preset 1; when the dome number is set as 2, to call preset2.
as current alarm input, to run alarm output or not.
NONE---none alarm output/AUX 1---the first alarm output
ALARM PRIORITY
alarm priority can be defined as three grades:
high, middle, low.
resume mode after relieving alarm input, there are two
choices: ON---clear alarm output, the dome will stop.
OFF---just clear alarm output.
set alarm reset and delay the time (1-225s)
how long to relieve and run
RESUME
after the dome receives alarm
message.
set state of the relay. N/C---often close the
state, N/O---often hold the state. If setting as often closing the state, the relay
is in closing the state when there is no alarm to output; when there is alarm to
output, the relay is in holding the state.
AL
to
ALARM SETTING
, press
OPEN
to enter the menu alarm setting
,
1
ALARM CONTACT
ARM SETTING
ARM SETTING
Operate joystick, move the cursor
ALARM NUMBER
ALARM ACTION
ACTIVATE AUX
、
【
】
● 【
】
● 【
】
【
】
【
】
● 【
】
● 【
】
● 【
】
● 【
】
● 【
】
● 【
】
● 【
】
、
RESUME
RESET DELAY
2
ALARMS
RESUME
OFF
SEQUENCE
002
RESET DELAY
020
ALARM CONTACT N/C
ALARM SETTING
ARM SETTING
BACK
EXIT
ALARM SETTING
ALARM NUMBER
001
ALARM ACTION
TOUR
ACTIVATE AUX
NONE
ALARM PRIORITY
HIGH
BACK
EXIT
This function is relative with the type of the dome, if zoom camera hasn this function, it is invalid.
't
Earthing
Alarm input 1-4bits
Alarm output 1
GND
1
2
3
4
ALARMS
AUX1
33
MAIN MENU
SYSTEM SETTING
CAMERA SETTING
FUNCTION SETTING
WINDOW BLANKING
ALARMS
EXIT
Alarm Function