9
WIRING
Your DE-1008.5 is shipped with the power cord assembly, Part #364-1008.5, connected to
the SP-2L Control. The power cord assembly has two sections.
•
The first section, Part #364A, will be installed
from your power supply to the SP-2L Control.
•
The second section, Part #364C, will be
installed from the SP-2L Control to the pump
assembly.
•
Remember, when shipped, both sections are
connected to the SP-2L Control.
SP-2L CONTROL
•
Find a mounting location for the SP-2L Control. It is recommended this be in a location
within easy reach of the operator.
•
Mount the controller using either the included self-
tapping screws or the ¼” nuts and
bolts.
•
If you are using the self-tapping
screws, drill a 3/16” pilot hole in the desired screw
location.
•
REMINDER: Cutting off factory plugs and/or wires, or opening case, of the SP-2L
Controller voids warranty.
FM-1008.5-LED
•
On the backside of the SP-2L Control, there is a third wire lead. It is black and red with
white stripes.
•
This lead will only mate up to the power cord that is attached, and part of, the
FM-1008.5-LED Flowmeter.
•
FM-1008.5-LED Flowmeter will become illuminated
when power to the SP-2L is turned on, and the pump
motor is running.
•
To make running the wiring easier, do not connect
until after you have installed both the SP-2L Control and
the FM-1008.5-LED Flowmeter.
•
When disconnecting, ALWAYS pull on the
fittings
– NOT on the wires.
364A
364C
364-1008.5
