10
WIRING
1.
Part #364A has bare wires and fuse holder. This end will be
connected to your 12 Volt DC power source. You may need to change the
terminals to mate up with your power source. There are additional
connections found in the electrical pack, Part #170017.
•
ORANGE WIRE (w/FUSE HOLDER)
:
The orange/red wire must be
connected to 12 volt DC positive
(+)
. It is recommended this be connected to a
12 volt DC regulated power source, such as an in-cab power outlet, or a header
switch output. If wiring into a “header switch” output, the red wire should
be connected to the 12 volt DC
(+)
switched output.
Only install a 3 AMP Fuse
into the fuse holder.
•
BLACK WIRE
: The black wire should be connected to
(-)
ground. If wiring
into a header switch output, the black wires should be connected to the 12 volt
DC
(-)
output.
2.
The other end of Part #364A has a white plug on it. This plug
will mate up to the input wire connection on the SP-2L Control. On
the SP-2L Control, the wire lead will be black
(-)
and red
(+)
.
3.
Part #364C has a white plug on one end. Connect this output
wire connection to the SP-2L Control. On the SP-2L Control, the
wire lead will be orange
(+)
and blue
(-)
.
4.
From here, Part #364C will be routed to the pump assembly.
On the bottom of the pump assembly, you will find a black plug.
The black plug on the end of Part #364C will connect here. The
plug can only connect one way. Mate up the plug and insert until it
CLICKS
. Additional details on
Page 11
.
170017
From Flowmeter to Controller: FM-1008.5-LED
From Power Source to Controller: 364A
From Pump to Controller: #364C
