11
PUMP PLUG DISCONNECT
•
On Part #364C there is a weather-tight latching plug which
connects to the DE-1008.5 Pump Enclosure.
•
To ensure proper connection, line up the fittings and press
together until it
CLICKS
.
•
To disconnect the power cord, press the black clip in the center,
and pull the electrical fittings apart.
•
ALWAYS pull on the fittings
– NOT on the wires.
•
HELPFUL HINT:
If it is difficult to disconnect the power cord
from the enclosure, try this:
o
Push the plug portion of the power cord further into the fitting on
the enclosure. It sounds weird, but yes, plugging it in more. This
will break the weather-tight seal.
o
Then, try unplugging the fittings
.
HEADER SWITCH WIRING
•
Your chopper must be equipped with this option and you must have the electrical
connections to mate up to the chopper’s plug.
Dohrmann Enterprises, Inc.
does not
stock the
factory
plugs for header switch connections. Header switch adapters can be
purchased from your local implement dealer.
•
Dohrmann Enterprises, Inc.
does offer a compatible header switch adapter plug for:
o
John Deere
7000, 8000 & 9000 Series Self-Propelled Forage Harvesters
▪
Part #190000
▪
Can be used in place of John Deere Part #AZ100126
o
Claas
Self-Propelled Forage Harvesters
▪
Part #210000
NOTE:
For any wiring, be sure you have good, clean terminals, and a good connection. This
system must be connected to a 12 volt DC system. A 6 or 24 volt system
WILL NOT
work.
After everything is wired, if the control does not work, it has most likely been wired in reverse.
Change the red and black wires at the power source to correct this problem.
