Shunts – Keeping the
Timid Pups
happy
If you feel your dog is receiving too strong of a correction, you can add a shunt to
the receiver that will decrease the amount of pulsation. This small device fits over
the receiver’s contact posts and come in multiple correction strengths. The shunts
reduce the correction level to the value of the shunt. For instance, a 5k shunt
reduces the correction to 5000 volts. Shunts available are:
DG9000 Receiver – 1k, 2k, 4k, 5k
DG5000 Receiver – 1k, 3k
DG3000 Receiver – 1k, 2k
DG9000 RECEIVER
Nylon Washers
Collar
Posts
Lock Washers
Probes
Shunt
1.
Place collar on receiver over contact posts.
2.
Place nylon washer on each post.
3.
Put shunt on over nylon washers, flat side down.
4.
Place one lock washer on each post.
5.
Put “Loctite” (blue, non-permanent only) on post, or inside probe.
6.
Screw on probes. Do not over-tighten! Snug with wrench.
17
Summary of Contents for DG9000
