5. Run twisted pair from transmitter to point where you exit outside to meet loop.
•
To secure it in position, staple the twisted pair along base of inside wall.
•
Decide where you’ll drill a hole to run the twisted pair to the outside. Drill the
hole with 3/8” bit and run the wire through this hole.
•
After the wire is through this hole, fill the hole with silicone sealant.
6. Bury twisted pair in a straight line from the house to where it will meet loop.
•
Cut an angled trench at least 3” deep.
Angled trench in ground
•
Lay the twisted pair in the trench.
•
Stamp ground to close the trench.
•
Leave ends of twisted pair exposed to splice to the wire loop.
8
Summary of Contents for DG9000
