Assembly of DG9000 / DG5000 / DG3000 Receiver
DG9000 RECEIVER
Nylon Washers
Collar
Posts
Lock Washers
Probes
1.
Place collar on receiver over contact posts. Place nylon washers on each
post.
2.
Place lock washers on over nylon washers.
3.
Put “Loctite” (blue, non-permanent) on posts, or inside probe.
4.
Screw on probes.
Do not over-tighten!
Snug with wrench.
When putting battery in receiver, the “+” sign faces toward you.
DO NOT let your dog wear the collar until the system has been adjusted and
you are at the appropriate point in training.
The collar will beep whenever it is in the signal field while field is on.
ALWAYS remove your dog’s receiver collar BEFORE your dog comes
indoors. This is to avoid unintended signal interference with receiver.
The receiver battery compartment is NOT WATERTIGHT. In order to comply with
your warranty, there must be an O-ring on the battery cap at all times.
15
Summary of Contents for DG9000
