Dog Guard DG9000, Installation And Training Manual

Page: 17 / 41

Dog Guard Receiver Collars – DG9000, DG5000 & DG3000
The receiver must be placed on the outside of your dog’s collar so that it is
situated horizontally under his neck. To do this, follow the steps below:
1. Fit the nylon collar to your dog’s neck.
2. If using your dog’s existing collar, take it off your dog’s neck and buckle it
through the same hole it was buckled through when it was on your dog.
3. Hold the buckled strap by the buckle so that it hangs vertically. When the
receiver is attached to the strap it will hang under your dog’s neck, directly
opposite the buckle.
4. Lay the receiver along the collar so that the two threaded projections match the
collar holes for the receiver and probes. * For assembly instructions see pg. 15.
5. Make sure the probes protrude on the inside of the collar so they touch your
dog’s neck. Use large probes for longhaired dogs and small probes
for
shorthaired dogs.
Check your probes periodically to make sure they are tight if
you are not using thread locker
14
To ensure a consistent signal, the dog’s collar must be
secured as illustrated below. To do this, make sure the
probes are closest to the dog’s chest so that the receiver
hangs down at a slight angle.
Note: Because some T.V. sets
may activate the receiver,
please remove the receiver
from your dogs neck when
he/she enters the house.