C L 1 U S E R S G U I D E
D O D T E C H N O L O G I E S , I N C
Rev 10.07
Page 4
2.1.5 A/C Power & Switch
A/C power is connected on the left side panel with a standard power cord. The on/off power
switch is located adjacent to the power cord connection.
2.1.6 14 Pin I/O Connector
The connector on the side of the unit connects to alarm relays, fault relays, 4-20ma output, and
the remote reset input.
2.2 Maintenance area
The maintenance area allows easy access for changing ChemLogic tape in the CL1. Figure
2.2 shows the internal layout with the access panel open. See section 6.3 for tape installation.
Figure 2.2
2.3 Internal Layout – Service area
Internal access to the CL1 for service uses the latches located on the right side of the front
panel. Figure 2.3 shows the internal layout of the CL1 with the service door open.
The door should be opened by trained service personnel (See section 6.2)
. IMPORTANT:
End of line filters are required. See section 6.4
DANGER:
Turn off the unit and disconnect A/C power to the unit before
opening the Service Door.
