28
AT Commands
Overview
Parameters/Descriptions
Command
Examples
AT*DGPIR=<n>
Set whether to show
or hide the caller ID to
the access point during
packet communication.
The setting of this
command is enabled
when a call is made.
This setting can also
be set by adding
184 (hide) or 186
(show) to the access
point number when
confi guring the dial-up
network settings.→P18
n=0 : Connect with the APN
setting as is.
n=1 : Connect with 184 (hide)
added to the APN.
n=2 : Connect with 186
(show) added to the
APN.
AT*DGPIR?
: Display the current setting
value.
AT*DGPIR=0
OK
AT*DGPIR?
*DGPIR:0
OK
AT*DRPW
Display the received
power indication value
of the FOMA terminal
(minimum value to
maximum value: 0 to 75).
−
AT*DRPW
*DRPW:25
OK
AT+CACM="<pas
swd>"
Reset the cumulative
billing value recorded on
the UIM (FOMA card).
passwd: PIN2 code
If the entered PIN2 code is
correct, the cumulative billing
value is reset.
("1234" is entered
for the PIN2 code)
AT+CACM="1234"
OK
AT+CBC
Display the battery level
of the FOMA terminal.
Result format:
＋CBC:<bcs>,<bcl>
bcs=0 : Power is supplied from
the battery pack
bcs=1 : Power is not supplied
from the battery pack
bcs=2 : The battery pack is
not connected to the
FOMA terminal
bcs=3 : A call cannot be
made from the FOMA
terminal as a result of
a power supply error
bcl : Remaining battery
power is displayed
with a value from 0
to 100
AT+CBC
+CBC:0,70
OK
AT+CGDCONT
Set access point (APN)
for packet communication.
See P34.
See P34.
AT+CGEQMIN
Register the threshold
to accept the QoS
(Quality of Service) sent
from the network when
packet communication
is established via a PPP
connection.
See P34.
See P34.
AT+CGEQREQ
Set the QoS (Quality of
Service) to be requested
from the network when
packet communication
via PPP connection is
dialed.
See P34.
See P34.
AT+CGMR
Display the version of
the FOMA terminal.
−
AT+CGMR
XXXXXXXXXXX
XXXXX
OK
Continue on the next page
