Docomo Style F-02A, Instruction Manual

Page: 81 / 469

79
Sound/Screen/Light Settings
✔
INFORMATION
･
It does not vibrate when receiving a call/mail during a call.
･
Even with "OFF", the vibrator may operate when Flash graphics operate.
Melody Call
Changing ring tone
This is a service to let the caller to FOMA terminal hear melody instead of ring alert.
･
A communication fee is free for connecting to the setting site. Note that packet
communication fees are charged for connecting to IP site, i-mode menu site or
Free Melody Corner.
･
Melody Call is valid only when a voice call is received.
1
m
[Settings & NW services]
117 e
"Yes"
The melody call site is connected.
･
For details, refer to "Mobile Phone User's Guide [Network Services]".
Setting System sound
1
m
[Settings & NW services]
114
2
Perform necessary operation
Setting Keypad sound :
1 e 1
-
5
･
When the sound of Battery level and End alert of Data exchange settings are
set to "ON", sounds are emitted according to these settings.
･
When setting to "OFF", the confirmation sound is not emitted when reading
a code.
･
Even when a sound is set to be emitted, it is not emitted when pressing
T
or
SD
, or while i-
α
ppli is running (except
s
).
Setting Open/Close sound :
2 e 1
-
4
Setting Shutter sound :
3 e 1
-
5
･
This setting also applies to Shutter sound of Image settings.
Setting Movie camera sound :
4 e 1
-
5
･
This setting also applies to Shutter sound of Recording settings.
Charge alert
Setting confirmation tone for charging
You can set if you activate the battery charging sound at the start and end of
charging.
1
m
[Settings & NW services]
115 e 1
or
2
✔
INFORMATION
･
Even when "ON" is set, the charge alert does not sound in the cases below.
- In Silent mode, Public mode (Drive mode), during a voice/videophone call, 64K data
communication, i-mode communication and packet communication
Setting Call session
On-hold tone : Set On-hold tone.
Quality alarm : Set alarm sound when the call is about to be interrupted.
･
The call may be interrupted without sounding the alarm depending on the call
conditions or radio wave conditions.
Reconnect alarm : Set alarm for reconnecting interrupted call.
･
While the call is interrupted, the other party hears no sound.
･
The time required for reconnection differs depending on the call conditions or
radio wave conditions. It normally takes 10 seconds at most.
･
You are charged for the time used for reconnection (up to 10 seconds).
･
The call may be interrupted without sounding the alarm depending on the call
conditions or radio wave conditions.
Low Battery alert : Set if you activate the alarm when the battery is about to be
exhausted.
･
When the battery becomes low during a call, the alert is emitted from the earpiece
even with "OFF" set.
1
m
[Settings & NW services]
116
2
Perform necessary operation
Setting On-hold tone :
2 e 1
-
3
Setting Quality alarm :
3 e 1
-
3
･
Operation during a voice call :
m5
Setting Reconnect alarm :
4 e 1
-
3
･
Operation during a voice call :
m4