DoAll TF-2025M, Instruction Manual

Page: 13 / 34

9
COOLANT INSTALLATION
1. Install the coolant pump by attaching it to the
mounting bracket inside the coolant tray with screws
provided.
Coolant Installation.
2. From the rear, slide the coolant tray between the
deflector shields all the way in and under the saw
head with the coolant pump to the rear of the
machine.
3. Fill the coolant reservoir with 20 gallons (75.7 liters)
of oil or cutting fluid recommended by the Lubrication
Chart. DO NOT let coolant spll over the tray and
onto the floor.
The coolant pump intake must be sufficiently
submerged for coolant flow to reach all areas
n the coolant system.
PREPARATION FOR USE
1. Check to be sure all safety guards, covers and doors
are in place, closed and/or secured.
2. Remove the protective Saw Cap from the saw band
by opening the upper bandwheel door and carefully
pull the cap off the saw band. Then closed the
bandwheel door.
3. Check to see that all other points listed by the
Lubrication Chart have been properly checked
and/or serviced.