30
MIST LUBRICATOR
1.
The mist lubricator has a reservoir mounted in the
rear of the machine with a nozzle unit mounted
above and left of the lower bandwheel near the
band wiper.
2.
See the literature sent with your machine on
recommendations and operation of the mist
lubricator unit.
OUTBOARD VISE (Rght Hand Vse)
1.
The outboard vise is mounted on the right side of
the saw band and used for job requirements where
more clamping or holding power is needed.
2.
A selector switch on the control panel operates the
vise in the same fashion as the left vise with "OPEN",
"HOLD" and "CLAMP" settings.
Make sure the vse jaw s opened wde enough
when movng materal through the outboard
vse.
LIFT ROLLERS
1.
The lift roller is used to help manually feed the
material along into the cutting area. This roller can
be mounted on either side of the saw band.
2.
A selector switch on the control panel operates the
lift roller (left and/or right hand) with "UP" or "DOWN"
settings.
LASER LINE OPTION
To avod eye damage, DO NOT stare nto the
laser beam.
1.
A laser devise is used to emit a line on the material
to be cut. This line shows the approximate spot
where the cut will take place.
2.
The devise is controlled by a selector switch with
"ON" and "OFF" settings and is located on or near
the control panel. Turn the laser "OFF" when not
in use.
3.
The laser is adjustable to position the laser beam
where desirable.
4.
When the laser is turned on, a warm-up period of
3 to 5 seconds take place before a line appears. If
the line is difficult to see, darken the work area to
enhance the line.
5.
Remove the protective shipping cap from the laser
devise before operation.
FIXED HEAD (NON-TILTING)
1.
This factory installed option does not allow tilting of
the saw head.
3°
HEAD CANT
1.
This factory installed option tilts the saw head forward
three (3) degrees from vertical for easier and faster
cutting of structural and other certain materials.
Contact a DoALL sales representatve for
nformaton on all your cuttng applcatons.
MATERIAL HANDLING EQUIPMENT
1.
Special material handling equipment can enhanced
the performance of your machine. Contact your
DoALL sales representative for information on any
material handling needs that could increase your
productivity.
Summary of Contents for TF-2025M
