12
CONTROL CONSOLE (Continued....)
Typical Pushbutton Panel.
11.
Head Angle Rapd.
Used in conjunction with the
Head Angle
selector switch, pushing and holding
this pushbutton accelerates the rate of speed the
saw head moves while rotating the saw head.
12.
Head Angle.
This selector switch with "-", "HOLD",
and "+" settings regulate the direction of head tilt and
shows the angle in degrees on the display above.
Head Angle Orientation.
•
Turn the selector to "-" or left causes the head to
pivot to the left or negative direction.
•
Turn the selector to "+" or right causes the head to
pivot to the right or positive direction.
•
Turn the selector to "HOLD" stops head movement
in either direction.
13.
Band Speed Dsplay.
This display shows the
factory-set band speed in feet per minute or meters
per minute.
14.
Band Speed.
Turn this knob to adjust band speed
between 50 and 400 fpm (15 to 122 m/min.).
Rotate
clockwse
to "increase" the band speed;
counterclockwse
to "decrease" it.
8.
Post.
This selector switch with "DOWN", "HOLD",
and "UP" settings regulate post movement.
•
(a)
Rotating the selector to "DOWN" lowers the
post;
(b)
The "UP" position raises the post;
(c)
The
"HOLD" position stops post movement.
When the saw head s rotated, make sure the
post s postoned to clear the materal. Falure
to do so wll result n damage to the post.
9.
Operaton.
This selector switch with "MANUAL"
and "AUTO" settings determines the machine's
operating mode. Make your selection
before
starting
the band drive motor.
•
Placing the selector to "MANUAL" will stop all
machine functions at the head forward position
following the completion of each cut.
•
Placing the selector in "AUTO" permits a full cycle
mode following the completion of cuts;
(a)
The saw
band drive motor will stop;
(b)
The saw head will
return behind the vise jaw;
(c)
Hydraulics will remain
on.
10.
Head Angle Dsplay.
This displays the angle of
the saw head in degrees from vertical.
•
When the saw head is tilted to the left, the display
shows a "-" or negative angle; when tilted to the
right, no sign is shown or positive angle.
Summary of Contents for TF-2025M
