42
ACCESSORIES
ROLLER STOCK CONVEYORS
1.
Your machine may be equipped with one of the
following roller stock conveyors for moving long
stock into cutting position (or as an unloading
adjunct). The following conveyors are available:
•
Stock conveyor five (5) feet (1525.0 mm) long by
18 inches (457.2 mm) wide with a weight capacity
of 800 pounds (362.9 kg) per roller.
•
Stock conveyor ten (10) feet (3050.0 mm) long by
18 inches (457.2 mm) wide with a weight capacity
of 800 pounds (362.9 kg) per roller.
Roller Stock Conveyor.
2.
To install a roller stock conveyor:
(a)
Position
the assembled conveyor(s) behind or in front of
the machine base; (b) Adjust the conveyor to the
machine with the leveling screws on the conveyor
legs. The top of the front conveyor roller should be
inline to 0.010-inch (0.25 mm) above the vise bed
wear plate.
3.
The remaining rollers must be parallel to, and in the
same plane with the vise beds to within 0.010-inch
(0.25 mm) per 24 inches (609.6 mm) of travel.
4.
Depress the roller shafts for ease of installation or
removal of rollers.
The conveyor DOES NOT attach to the machine
base. Anchor the conveyor to the floor after
all leveling and adjustments are made.
VERTICAL GUIDE ROLLERS
1.
Vertical guide rollers are effectively used to help
maintain correct positioning of long stock on the
fedd table and/or conveyor.
2.
These can be installed between the interface plate
and conveyor or between conveyors (if more than
one is supplied).
3.
For nesting fixture, an additional vertical roller
is mounted to the index roller bed rail to provide
another laterally adjusted vertical roller ( the roller
on the fixed jaw side is standard).
4.
The vertical roller is adjusted along the guide rail
and clamped to the rail to laterally confine stock
when indexing.
Vertical Guide Roller For Conveyors and/or Nesting Fixture.
NESTING FIXTURE
1.
This optional feature is designed for high-production,
multiple sawing of stacked bars, rounds and tubing.
Its jaws have the capacity to hold stock from 5-1/4
to 12 inches (133.3 to 304.8 mm) wide, and from
4-1/4 to 8 inches (107.9 to 203.2 mm) high.
2.
Vertical nesting clamp cylinders are mounted to
the machine’s front and index vises. The cylinders
operate simultaneously with the regular vise
clamping cylinders.
The hydraulically operated Nesting Fixture can
also be used with the Variable Vise Pressure
control.
Stacking Stock
1.
Correct stock nesting is essential for proper clamping
of the vises and nesting fixture. It is important that
nesting vise clamping pressure be transmitted
to every stacked piece. Sometimes this can be
more easily accomplished by manually jogging the
stack.
Summary of Contents for C-4100NC
