30
•
If the fixed vise is not clamped, the
Display
will
show "Clamp Fixed Vise".
•
If the index vise is not clamped, the
Display
will
show "Clamp Index Vise".
•
If there is no stock in front of the out-of-stock
photoelectric sensor, the
Display
will show "Out-
of-Stock".
•
When a single job or a batch of jobs has
been completed, the
Display
will show "Jobs
Complete".
•
Each time automatic cycle starts, the first cut will
be a crop cut to square the end of the stockpiece
(done to insure cut accuracy).
4.
The operator can push the
Job
button, then edit or
enter jobs while the automatic cycle is running.
The
operator CANNOT edit the job being cut while
the machine is running.
5.
The operator may interrupt a job at any time and
return later to complete it.
6.
The operator can also set all "DONES" to "0", this
sets the quantity done to "0" for all of the jobs.
DO NOT remove any cut-off pieces until they
are away from the saw band or the saw band
has stopped completely.
For future reference, keep a record of band
speed, feed rate, feed force and coolant
application settings for successful jobs.
TYPICAL OPERATING PROCEDURES
(Continued....)
Summary of Contents for C-4100NC
