DNH DHVC5000 Series, Use Manual

Page: 18 / 48

15
1.3.4 Motor Parameters
Click the ‘Motor’ button on the Parameter Setup Screen to set the MVC motor parameters, as
shown in Fig.1-21. Set according to actual MVC and motor nameplate.
Fig.1-21Motor Parameters Window
1.3.5 Communication Parameters
Click the ‘Communication’ button on the Parameter setup Screen to set the MVC
communication parameters, as shown in Fig 1-22:
For MODBUS protocol communication, the baud rate of2400, 4800, 9600, 14400, 19200,
and 38400 are supported, the slave addresses (0-255) may be set to an integer value more than or
equal to 0 and less than or equal to 252. The check modes are EVEN, ODD, NONE, i.e. even
parity check, odd parity check, no check, corresponding values are 2, 1, 0.
For PROFIBUS protocol communications, The slave addresses may be set to an integer value
more than or equal to 0 and less than or equal to 252.
Fig.1-22 Communication Settings Window