15
In calibrated mode, the internal amplifier is engaged and signals from the transducer are filtered and conditioned
before the signal is sent to a data acquisition system via the BNC outputs on the rear of the interface. The total
voltage output from the BNC connectors is 2.5 volts.
POWER-UP SCREEN
After turning on the 820MS Interface, an “Introduction” screen
appears. The system is auto-calibrating the A/D converters while this
screen is displayed.
3.2 INTERFACE MENUS – CALIBRATED MODE
After a few seconds, the “ACTUAL FORCE” display will appear.
At any given time, if the force applied on any channel is out of range,
the force reading for the overloaded channel will turn yellow as a
warning.
