Web Power Switch
Pro
digital-loggers.com
4
Important Factory Defaults
IP:
192.168.0.100
User name:
admin
(lower case)
Password:
1234
To reset to factory defaults, gently
press the reset-to-defaults button
below the LCD to enter the reset
menu, then select a reset option.
Quick Setup
Use these shortcuts if you are an experienced installer. We recommend
reading the entire manual for first-time installation.
• Unpack. Save the carton. Attach the line cord. Power up.
• Attach an Ethernet cable from the controller to your LAN. Switch power
on. If you are attached through a switch, you may need to power-cycle
your switch to initially establish a connection.
•
Ping the default address 192.168.0.100 to confirm that a network
connection is established. If you don’t receive a response, proceed to the
IP Setup
section below.
• Log in to the Pro using the default user name
admin
and the password
1234
Note:
“
admin
” must be entered in lower case.
• Click the
Settings
link to reach the configuration page.
Select the safest
power-loss configuration
for your installation: (all OFF, all sequential ON,
or pre-powerloss sequential ON) Note that pre-powerloss means the last
previously configured state, and it does not take cycling into account.
“Power loss” is defined as loss of AC power for more than 100ms.
•
Configure the Pro as described below. After each change, click Submit
and wait for the page to refresh before continuing.
Tip:
A three-bulb electrical safety-tester is handy for checking
configuration before attaching loads.
