DK Digital AVR-500, Owner'S Manual, Page: 5 / 28

About these instructions
The operation described here mainly refers to the use of the remote control handset (R/C).
Buttons with same or similar marking at the main unit have the same function like those of
the remote control (R/C).
Preparation for turning on
Place of erection
Ø
For setting up the unit please choose a location with sufficient air circulation around. That
prevents overheating. Don’t expose the unit to direct sunlight or other heat sources.
Ø
Do not pile up other units on top of your receiver. That would block the vent holes and
cause the device to overheat.
Before using the remote control
1. Please open the battery compartment.
2. Insert two batteries (1,5 V, size AAA). Please
make sure the polarity matches the marks
inside the compartment. Otherwise the r/c will
not work and may be damaged. Replace the
cover.
3. Please point the r/c towards the main unit when
operating its buttons.
The r/c works properly in a distance below 5m
and in an angle of up to 60° of the front of the
unit. No obstacles may stand in the way
between r/c and infrared sensor.
Ø
Should the r/c start to work unreliably replace
both batteries. We recommend using alkaline
batteries.
Ø
Batteries should not be disposed by
ordinary refuse disposal. Please lead empty batteries towards appropriate
collecting points. Never throw batteries into fire.
Ø
If you won’t use the r/c for some time, please remove the batteries from the
compartment, to prevent damage by leakage.
5