H-SW3000 USER MANUAL V1
< 6 >
Always connect the product to a protected circuit (circuit breaker or fuse). Make sure the product has an appropriate
electrical ground to avoid the risk of electrocution or fire.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel serves
only as a 0 to 100% switch.
4.2
AC Plug
The H-SW3000 comes with a power input cord terminated with a Lockable power connector on one end. The other end is
•
CN plug (CN market, etc.)
•
EU plug (EU market, etc.)
•
US plug (US market, etc.)
If the power input cord that came with your product has no plug, or if you need the change the plug, use the table below to wire the new
plug:
Connection
Wire (U.S.)
Wire (Europe)
AC Live
Black
Brown
AC Neutral
White
Blue
AC Ground
Green/Yellow
Green/Yellow
4.3
Resetting the Breaker
This product is equipped with a resettable breaker. If the breaker trips, all sections of this product will lose power.
•
Remove the power cord from mains power.
•
Allow unit to cool for 15 minutes.
•
After 15 minutes, you may attempt to reset the breaker by pressing the button with your finger.
•
Plug the product’s power cord into the power outlet and continue using as recommended.
4.4
DMX Linking
You can link the H-SW3000 to a DMX controller using a 3- or 5-pin DMX connection. If using other DMX-compatible products with this
product, you can control each individually with a single DMX controller. Instructions for connecting and configuring this product for DMX
operation are in the User Manual.
4.5
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes.
4.5.1
Orientation
For safety reasons, we do not recommend mounting the product in any capacity. Operate the product while it is on the ground only, and
make sure there is adequate room for ventilation, configuration, and maintenance.
4.5.2
Rigging
DJPOWER recommends using the following general guidelines when mounting this product.
•
Before deciding on a location for the product, make sure there is easy access to the product for maintenance and programming
purposes.
•
Make sure that the structure or surface onto which you are mounting the product can support the product’s weight (see the Tec
hnical
Specifications).
•
When mounting the product on the floor, make sure that the product and cables are away from people and vehicles.
