8.
• Grab the 8-pin right-angle female header and put it into the PCB
• Use two M2x10 bolts and put one of the 3.0mm black spacers on top of each
• Plug the Lepton board into the socket and through the two bolts, then save it with
two plastic nuts
• Pick up two more M2x10 bolts and put them into the empty holes on the top, then
save them with plastic nuts
• Use two more smaller black spacers and put them between the PCB and the
Lepton module on the marked position, as they do not fit on the bolts
• Solder the female header to the PCB and cut the pins short with cutting pliers
DIY-Thermocam V2 Assembly Guide
Page 8
DIY-Thermocam V2 Assembly Guide
