6.
• Use two of the M2 x 10 bolts and put them though the holes in the PCB
• On the left bolt, put one of the M2 x 3.5mm distance spacers, on the right bolt one
of the M2 x 3.0mm spacer, take care you choose the right length
• Put the visual camera module on top of the bolts, push the header into the PCB
and save it with two M2 plastic nuts
• Use the remaining M2 x 3.5mm spacer and put between the module and the PCB
on the left position marked, then use a M2 x 3.0mm spacer and put it on the right
side
• Push the module against the PCB, then solder the 8-pin header on the backside
and cut the pins short with cutting pliers
DIY-Thermocam V2 Assembly Guide
Page 6
DIY-Thermocam V2 Assembly Guide
