18.
• Put the display module on top of the PCB and safe it with the four remaining
distance bolts
• Screw them into the PCB as shown on the image and tighten them
• Insert the Lepton 2.0, 2.5 or 3.0 into the module, make sure you hear a click when
it snaps in
• Insert the coin cell battery into the holder, so that the side with the +-marker is on
the top
• Check with a multimeter, if the voltage between the pin labeled "VBAT" (battery)
and "GND" (ground) is above or equal to 3V
• If this is not the case, move the battery inside the holder a little bit, until you can
measure the voltage on the two pins
DIY-Thermocam V2 Assembly Guide
Page 18
DIY-Thermocam V2 Assembly Guide
