12.
• Grab the the six side panels from the enclosure and remove the protection foil
from both sides
• For all enclosure parts, the shiny side goes inside, whereas the matted side goes
to the outside
• Get the bottom panel and hold it so that the shiny side is looking towards you
• Fix the tripod socket like shown with three M2 x 8 bolts, three washers and nuts
and screw them very tight
• Make sure that the round plate of the socket is on the outside (matted side)
DIY-Thermocam V2 Assembly Guide
Page 12
DIY-Thermocam V2 Assembly Guide
