DITEC 0DT872, Installation Manual, Maintenance, Use

Page: 44 / 48

- 44 -
0DT872 01-12-2021
• Close the upper part of the plastic guides (
P
) by pushing on the outer side.
• Insert each tooth side edge ( Q ) of the curtain in the relevant guide, if necessary to make easier the operation
remove the higher screw ( R ).
• Roll down the curtain so the bottom edge is 0.5m beneath the curtain inlet slot.
REINSERT THE CURTAIN
H
G
I
9. MAINTENANCE TO BE CARRIED OUT EVERY 6 MONTHS
Regular inspections should be made according to national
regulations and product documentation by a Ditec trained
and qualified technician. The number of service occasions
should be in accordance with national requirements and
with the product documentation.
Safety Devices
• Check the correct operation of the safety device Linear
Encoder (SLE)
• Check the correct operation of the safety photocells
Side guides
• Check the guides wearing and the relevant curtain
sliding
Installation / Fitting
• Tighten the fitting screws of the uprights with the
crosspiece
• Check the anchoring of the door to the door frame
Motor
• Check the fixing of the motor to the relevant support
• Check if encoder is working and its battery level
• Check the brake disc wearing. If necessary replace
the disc
• Check motor silent block operation and integrity
Main Shaft
• Check the good bearing supports fixing
• Lubricate the support of the bearings by suitable grease
inlet
Zipper status
• Check wearing and cleaning of the zipper
Part Part number
Cycles / hour operation
Abusive
Environment
(1)
<10
Low Traffic
<30
Medium Traffic
>30
High Traffic
Months Months Months
Brake disc 622337 36 24 12 12
Upper guide
29448ARR
29448ARL
29448B
48 36 24 24
Lower guide BGBST 48 36 24 24
Guide compensation spring KSPRING 36 24 12 12
Lens group and spacer for SLE 6GLSLEC 36 24 12 12
Motor silent block 5AV402510 48 36 24 24
(1) Dirty or dusty environment, operating temperature near to 0°C or over 35°C, wind pressure within 20% of maximum limit.
9.1 Maintenance Plan
The table below shows the recommended interval - in months - when to replace parts during preventive maintenance.