Remote Control Setup
63
Improving Receiver Control
1
Press and hold the SAT mode button for three seconds, until all of the mode buttons light
up, and then let go of the SAT button.
2
Press POUND (#) twice. The SAT mode button will flash the same number of times as the
address number (for example, three flashes means address 3).
Confirming Remote Control Operation
1
Make sure the remote has fresh batteries and is in SAT mode.
2
Press SYSTEM INFO on the receiver front panel to display the system information screen.
3
Press RECORD on the remote control:
•
The Remote Address in the system information screen changes to match the address
preset in your remote control.
4
Press POWER on the remote control to turn on/off receiver.
Changing the Remote Control from UHF Pro to IR
Your receiver accepts both UHF and IR (Infrared) commands. The remote control only
outputs UHF Pro signals but can be changed to transmit IR commands by switching the
key at the bottom. This is also useful for programming an after-market universal learning
remote control to operate your receiver. Note that when the remote control is in IR mode,
you will need to use it from the same room to operate the receiver because IR signals do
not travel through walls or over great distances.
Model ID
Receiver CAID
Smart Card ID
Software Version
Boot Strap Version
Billing & Programming
Technical Assistance
Internet Address
Receiver Mode
Location ID
Remote Address
ViP612 CVR-SD
R0079256789-30
S1907972574-12
DNASP206 Dsh689
AEE2WAND-N
1010WAND
1-800-333-DISH(3474)
1-800-333-DISH(3474)
dishnetwork.com
Single Mode
87940875:00000004
IR/UHF Pro Band A
Help
Done
Cancel
