Dish Network DVR Satellite System, User Manual

Page: 81 / 147

Remote Control Setup
73
Operating Other Devices
4
To start learning commands for this mode, select one of the folowing choices:
• If you have found a code for the device and programmed it into the remote,
press and release RECALL (the Mode light goes off when RECALL is
pressed and comes on when released), then hold the RECORD button until
the Mode button is lit again (about three seconds). The Mode button remains lit
while learning.
• If the device code has not been programmed for that device or if you are
unable to find a code,
press and hold the RECORD button until the Mode
button is lit (approximately three seconds). The button remains lit while
learning.
5
On the DISH remote, press and release the button you want the DISH remote to learn
from the original device’s remote. The Mode light goes off and comes back on.
6
On the original device’s remote control, press and hold the button you want learned until
the Mode light goes out and comes back on. You may need to press and hold the button
on the original remote several times before the DISH remote learns the command.
• If the DISH remote learns the command, the Mode light blinks off and then back on.
• If the Mode light blinks three times or remains lit, the DISH remote did not learn the
command.
7
After a button has learned a command successfully, repeat step 5 and step 6 until all
commands you want have been learned.
8 Press and release one of the Mode buttons on the DISH remote to end the learning
sequence. This saves all the commands for that mode and exits learning to return to
normal remote control operation.
To cancel learning, do not press any buttons on either remote control for at least
20 seconds. The DISH remote control times out and returns to normal operation.
Note
: If the remote control batteries are too low for learning, all the Mode buttons blink
quickly eight times. Learning ends without saving learned commands, and the remote
returns to normal operation. Change the batteries and begin learning again.
Note
: No learned commands are saved if the DISH remote controls times out before
completion.
SA
T
POWER
I
MENU
GUIDE
B
R O
W S
E
T
H
E
M
E
S
MUTE
RECALL
E
PLA
Y
VOLUME
DVR
TV
VCR
AUX
TV
PAGE
CANCEL
INFO
VIEW TV
SKIP
FWD
FWD