Dish Network DVR Satellite System, User Manual

Page: 75 / 147

Remote Control Setup
67
Operating Other Devices
SAT Auto-Tune
Most snowy, blue, or black screen issues occur because the TV is set to the wrong
channel. Using the SAT Auto-Tune feature helps prevent these screen issues from
occurring on TVs connected to the receiver’s modulated output (usually TV2). Use SAT
Auto-Tune to program the correct TV channel for satellite viewing into the remote control.
When the SAT button is pressed, the remote sends that channel to the TV.
This feature is enabled by default; however, if you want to use this feature, the channel
must be programmed by following these steps.
Setting SAT Auto-Tune Channel
1
Make sure the remote control operates your TV.
2 Press and hold TV for three seconds until all four Mode buttons are lit.
3
Press STAR (*).
4 Enter the channel used for viewing (up to three digits in range of 002 to 125), for example
channel “010.”
5
Press POUND (#). The Mode button flashes three times to indicate programming was
successful.
6 Press SAT. The channel changes.