Dish Network DISH 381, User Manual

Page: 62 / 116

Remote Control Setup
55
Recover Button
Controlling the TV’s Volume
1
Press TV for four seconds, and then let go of it. TV will blink.
2
Press POUND (#).
3
Press the plus (+) side of VOLUME.
4
Press ZERO (0).
5
Press POUND (#). TV flashes three times.
Now make sure the remote controls the TV’s volume:
6
Press SAT.
7
Press the plus (+) and minus (-) sides of VOLUME. The TV’s volume changes and TV lights
instead of AUX.
R
ECOVER
B
UTTON
Use RECOVER if you accidentally change the channel or video input on your TV and cannot get
the picture back from your satellite receiver. When you press RECOVER as described below, the
remote control sends commands to your TV to change channels or video inputs to try to get you
back to watching satellite programming. This procedure works only if you have accidentally
changed the TV channel or video input. It does not recover lost satellite signal (See
Troubleshooting on page 82 for information on solving problems).
Note: The remote must be programmed to control the TV (and VCR, if applicable) for RECOVER
to work as described.
Note: RECOVER will first try to tune your TV to channel 3, then channel 4, and then other video
inputs with each press of RECOVER. You may need to press RECOVER up to 30 times to recover
your satellite TV video.
The following setup is required to use RECOVER:
• The remote control must be set up to control the TV and, if installed, the VCR.
• If a VCR is installed, make sure it is connected as shown on page 75.
Chapter 9 381.fm Page 55 Thursday, May 21, 2009 6:13 PM