23
P
OSITION
B
UTTON
Press the
POSITION
button to move the
PIP
window to different
positions on the TV screen. Each time you press this button, the
PIP
window moves to a different position. See your receiver user’s guide
for more information on using the PIP feature.
S
WAP
B
UTTON
Press the
SWAP
button to swap the video in the main display with the
video in the
PIP
window. See your receiver user’s guide for more
information on using the PIP feature.
R
ECOVER
B
UTTON
Use the
RECOVER
button if you accidentally change the channel or
video input on your TV and cannot get the picture back from your
satellite receiver. When you press the
RECOVER
button as described
in the following section, the remote control sends commands to your
TV and VCR (if set up) to change channels or video inputs to try to get
you back to watching satellite programming.
Note
: RECOVER
only works if the remote control has been set up to
control the TV and/or VCR, if connected (see
Setting Up to Control
Other Devices
on page 11).
This procedure works only if you have accidentally changed the TV
channel or video input. It does not recover lost satellite signal (see
Troubleshooting the Kit
for troubleshooting information). The
following setup is required to use the
RECOVER
button:
•
The remote control must be set up to control the TV and, if
installed, the VCR (see your satellite receiver’s
User Guide
or the
Installation Instructions
).
•
If a VCR is installed, make sure it is connected as shown in your
satellite receiver’s
User Guide
.
To use the
RECOVER
button, complete the following instructions:
1. Press and hold the
RECOVER
button until all four mode buttons
light, and then let go of the button. The
SAT
mode button flashes
twice and then all four mode buttons flash three times.
2. Press the
RECOVER
button. Wait for the
TV
or
VCR
mode
button to flash once and then all four mode buttons to flash once.
Pyramid.book Page 23 Wednesday, February 16, 2005 4:00 PM