9
S
ETTING
U
P
THE
R
EMOTE
C
ONTROL
I
NSTALLING
B
ATTERIES
The remote control requires AAA batteries. When you
replace old batteries, you should replace
all
of the
batteries. Use batteries of the same kind,
for example
,
alkaline or carbon zinc, and
don’t
mix batteries of different
kinds. Alkaline batteries last longer.
1. Press down on the battery cover and slide the cover
off.
2. If you are replacing batteries, take out all of the old
batteries.
3. Put the new batteries in. Make sure
you match the plus (“+”) ends with the
plus markings on the battery case.
4. Slide the cover back into place.
S
ETTING
U
P
TO
C
ONTROL
THE
R
ECEIVER
The remote and the receiver must be set up on the same address so that
the remote can control the receiver. When you get the kit, the remote is
set up to control the receiver on address 1. However, your receiver may
be set to a different address. There are two ways to set up the remote
and receiver to work together on the same address. One way is to
simply use the address from the existing IR remote control. If you do
not have the existing IR remote control, use
Changing the Receiver and
Remote Control Addresses
on page 10.
1. On the existing remote control, press and hold the
SAT
mode button for three seconds until all mode buttons light.
Then, let go.
2. Press the
POUND
(
#
) button twice while watching the
SAT
mode button.
3. Count the number of times the
SAT
mode button flashes.
This number is the remote address. For example, if the
SAT
mode button flashes 6 times, this indicates the
remote address is set to 6.
Write the number here: __________
Note
: If using more than one UHF Pro remote control in your
house, make sure that the remote controls are set to different
addresses from each other.
Pyramid.book Page 9 Wednesday, February 16, 2005 4:00 PM