SJ3013 & SJ3014 micro
236613ACA
51
Charge the battery
Section 6 – Procedures
6.4 Charge the battery
1.
Supply sufficient airflow for the batteries and the
charger.
2. Do a visual and manual inspection of the DC
output wires and terminals. Make sure they
are in good condition before each use.
3.
Make sure the batteries are connected before
you charge them.
4.
Remove the battery vent caps and look at the
battery acid level. If it is necessary, add sufficient
distilled water to only cover the plates. Do not
put too much water in before the charge cycle.
5.
Install the battery vent caps.
6.
Connect the power supply cable
at the back
of the chassis
to a correctly grounded socket
between 100 to 240 VAC, 50/60 Hz.
7.
The charger shows when the battery is fully
charged.
8.
Look at the battery acid level when the charge
cycle is complete. Add distilled water to the
level of the bottom of the fill tube. Do not put too
much water in.
WARNING
Electrocution hazard. Do not put the charger in
water. If you do not obey, there is a risk of death or
serious injury.
CAUTION
Burn hazard.
Do not touch the surface of the
charger when it is in operation, especially in higher
temperature environments.
Let the charger cool
before you touch it. If you do not obey, there is a
risk of injury.
WARNING
Explosion hazard. Be careful when you use fuels,
solvents, or other flammable materials near the
charger or batteries. A spark from the charger or
batteries can cause a fire or explosion. If you do
not obey, there is a risk of death or serious injury.
NOTE
Many conditions have an effect on the battery charge
time. These include: the battery amp-hour capacity, the
remaining charge, the temperature, and the condition
(new, used, and defective).
WARNING
Explosion hazard. Do not disconnect the DC
output wires near the batteries when the charger is
ON. This can cause an arc, which can then cause
the batteries to explode. You must disconnect the
AC power supply cable from its socket, and then
the charger DC connections. If you do not obey,
there is a risk of death or serious injury.
WARNING
Electrocution hazard. Do not touch parts of the
charger output wires that are not insulated, the
battery connector, or the battery terminals. If you
do not obey, there is a risk of death or serious
injury.
WARNING
Do not charge the batteries in hazardous areas.
To
order go
to
Discount-Equipment.com
