ElitePro Setup Guide
26
Step 13
Start The Job
Now you are ready for the unit to start a job. Click on the
START
button.
The autoloader should move to the input spindle, pick up the 1
st
CD (your master) and place it
into one of the recorders. The image on the CD will be copied to the hard drive. Then the CD
Master will be removed from the Drive and place on the output spindle. Then the autoloader
will place a blank CD from the input spindle into each of your CD recorders. Next, the image
will be recorded onto the media. After that, the autoloader will pick up the recorded disk from
one of the recorders and carry it to the top of the column and wait for the CD Printer to open.
The recorded CD will be placed into the printer tray and the CD will be printed. After printing,
the autoloader will pick up the CD from the printer and place it on the output spindle. This will
repeat for each of your recorders. Once all your recorders are empty, the autoloader will take
more blank CDs from the input spindle and reload the recorders. This cycle will continue until
the 25 copies are completed.
If the unit is trying to use a CD recorder on your PC, or if you get an error message when trying
to print, please read the
Using Drive Assigner
section located on the next page of this guide
for some steps to correct the problem.
Please observe the operation and verify that everything works smoothly. If anything does not
work, back track and review your steps. If you cannot find the problem please call customer
service and one of our technical support staff will gladly assist.
