ElitePro Setup Guide
16
Step 9
Load Blank CD’s and Start Duplication
You are now ready to begin a job or task on the autoloader. Turn on your unit if you have not
already done so. Refer to step seven if necessary. The next steps will take you through a
typical setup and usage of the autoloader. It is recommended to follow these steps and
produce a test job, then move on to the many other functions and features of the autoloader.
Load blank Ink Jet media, data side down, onto the input spindle. The input spindle has three
silver rods located around the outside edge of the media. Please be sure the media does not
stick together and that the media lays flat in the input spindle. You may use the included gray
plastic alignment rod to help ensure that the CDs are properly aligned.
Place a CD-R to be copied on top of the blank media in the input spindle. This will be the
‘master’ for this test run. Use a image of 30 MB or less to allow the test run to be faster.
On the Desktop, click on the
DiscJuggler ICON
and the DiscJuggler will run.
Click on
File
, choose
New
and the panel below will open.
Choose
Copy CDs and DVDs from the same burner
(This task will take the CD on the top of the Input Stack; load a temp image to the hard drive
and copy from the temp image.)
Screen of Start of a New Job
