9
*REGULAR MAINTENANCE:
Each time the dirt container is emptied, the filter should be cleaned. Tap the filter firmly
against the inside of a trash can until the dirt stops falling from the filter. (Filter will be discolored after use, this will
not affect the filter’s performance.) Do not brush the filter. The cleaning instructions may vary depending on the dirt
conditions. In some cases, more or less cleaning of the filter may be required.
DIRT CONTAINER & FILTER REMOVAL & REPLACEMENT: CONTINUED
Return foam filter to filter cartridge.
6.
Return filter cartridge to base of
cleaner.
5.
Hold foam filter under running
water to wash. Ring excess
water out of filter. Allow filter to
dry for at least 24 hours before
replacing in filter cartridge.
7.
To remove Air Directors, rotate
1/4 turn counterclockwise.
Click buttons back into place
to lock filter cartridge in base of
cleaner.
8.
9.
TO CLEAN THE AIR DIRECTORS
Return dirt container to cleaner.
Align slot on bottom of dirt
container with tab on cleaner.
Push to snap into place.
Dry and return the Air Directors
to the dirt container. Rotate
1/4 turn clockwise to lock in
place.
11.
12.
REPLACE DIRT CONTAINER
Pull out and wipe with a damp
cloth to clean.
10.
WASH FOAM FILTER
REPLACE FOAM FILTER
REPLACE FILTER CARTRIDGE
Secure by aligning the three
(3) tabs in the base slots.
SLOTS
TABS
10
TOOL REQUIRED: PHILLIPS OR FLATHEAD SCREWDRIVER
WARNING:
TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG CLEANER BEFORE CHANGING BELT
OR BRUSHROLL.
BELT OR BRUSHROLL: REMOVAL & REPLACEMENT
5
BELT STYLE
For Belt Style 5 replacement, please call 1-800-321-1134 or visit our website at
www.dirtdevil.com to locate a dealer nearest you.
Lay cleaner flat and flip cleaner to expose
nozzle base. Base should lay flat and
face up. To remove nozzle guard, use
Phillips screwdriver to remove the three
(3) screws. Arrows show location of
screws.
Lift and remove brushroll.
Dispose of old belt.
1.
3.
Pull and lift nozzle guard off.
2.
TO REMOVE BELT
Slide belt onto motorshaft.
5.
Place new belt in area of
brushroll without bristles.
4.
TO REPLACE BELT OR BRUSHROLL
With new belt in
place, pull and
slide brushroll
into nozzle
making sure
that the
brushroll end
caps are in the
correct orientation
(6a inset).
Rotate brushroll manually to make sure belt is
properly aligned.
6.
6a.
MOTOR SHAFT
Reattach nozzle guard.
8.
7.
Replace all three (3) screws
to secure nozzle guard.
9.
