DirecTV HIRD-E4, Owner'S Manual

Page: 32 / 90

HUGHES BRAND DIRECTV PLUS™ DIGITAL SATELLITE RECEIVER
P
AGE
4-10
4) Using a carpenter’s level,
plumb the satellite dish antenna mast in at least two different
locations on the side of the mast, as shown. These two
measurements should be at right angles to each other. If the
mast is plumb (aligned vertically with the bubble level), go to
step 5. Otherwise, loosen the pivot bolt and adjustment nuts (see
diagram).
5) Rotate the mast until it is plumb with the level, then tighten the
pivot bolt and alignment nuts. If you are still unable to align the
mast with the level, try using wooden shims. If they do not
correct the problem you will need to find another install site.
6) Use a pencil to mark the location of the top left outside hole of
the base plate (see diagram) onto the cinder block surface.
7) Set the mast assembly aside and drill a ½-inch hole where you
made the pencil mark.
8) Clean out the hole.
9) Install the toggler as follows: Holding the ring end of a toggler,
fold the metal channel flat against the toggler and insert it into
the drilled hole until you feel the channel open inside the hollow core of the cinder block.
Rotate the toggler and gently pull the ring to ensure the metal channel is flat against the inside
of the cinder block. While pulling the toggler toward you to apply tension, slide the push-cap
until it is snug against the cinder block. Break the ring along the center perforation and bend
the two straps away from each other until they break at the push-cap.
Toggler installation steps.