8
For models with staff control in foot panel - cable
install and routing:
1. Raise the bed to a comfortable working height and raise the
foot section with the pendant. Then unplug the bed.
2. Locate the two staff control cables. Lay them out side by
side with one cable reversed. A male and female connection
should be at each end.
3. Unplug the pendant. Route one cable under the control box
and plug into pendant port. Route the second cable under the
control box and connect to the hand pendant (Figure 9).
4. Route the two cables under the main frame toward the foot
end. Zip tie the two cable ends on top of the foot end cross
tube (Figure 10).
5. Route cables tightly under the main frame tube. Gather and
bundle the excess cables nearest the next cross tube and
away from the leg mechanism (Figure 11).
6. Zip tie as shown by arrows (Figure 12).
Figure 9
Figure 10
Figure 11
Figure 12
Installation
(cont.)
