6
Baseboard Bumper
Recommended Tool: Rubber mallet
1. Place the baseboard bumper as shown (Figure 1).
2. Tap into place with a rubber mallet or press firmly with
the sole of your shoe until it locks into place as shown
(Figure 2).
Mattress Stops
•
WARNING: Possible Injury.
Sitting on, or sliding over,
mattress side stop, can cause injury to the skin when used
with mattress that compresses to less than 1.5 inches
under load.
•
WARNING: Possible Injury.
Make sure mattress fills
the entire width between side stops. Failure to do so could
result in injury.
Tools Required: #2 Phillips screwdriver
1. Locate the screws at each corner of the inside tube at
the foot end of the screws mattress support platform;
one per side (Figure 3).
2. Remove the screws using the #2 Phillips screwdriver;
do not discard the screws.
3. Position and insert the mattress stops in the holes
provided (Figure 4). Reinstall the screws removed in
step 2.
4. Locate the screws in the holes in each corner of the
inside tube at the head end of the mattress support
platform; one per side.
5. Remove the screws using the #2 Phillips screwdriver;
do not discard the screws.
6. Position and insert the mattress stops in the holes
provided. Reinstall the screws removed in step 5.
Figure 2
Figure 1
Figure 3
Figure 4
Installation
•
CAUTION:
Carefully remove the packaging straps (orange zip ties) before attempting to operate the bed.
•
CAUTION:
Prior to operation, refer to operating conditions above to ensure bed electronics are within ambient
temperature.
Check that all parts of the bed were delivered and inspect for damage.
Parts to Prepare:
a. Bed Frame
b. Pendant
c. End panel(s)
