Direct IP XR408, Operation Manual

Page: 51 / 86

Part 3 - Configuration
51
- Select : Confirm the block selection in the
selection window.
-
Clear
: Clear the block selection in the selection
window.
-
Reverse
: Clear the blocks selected within the
selection window and select all unselected blocks
within the selection window.
- Select All : Select all blocks.
- Clear All : Clear all block selections.
-
Reverse All
: Clear all selected blocks within the
screen and select all unselected blocks within the
screen.
-
OK
: Save the changes and exit the menu.
- Cancel : Exit the menu without saving the
changes.
• Min. Blocks : Motion needs to be detected in more
than the specified number of blocks in order to
trigger a Motion Detection event. You may select a
value between 1 and the number of blocks selected
under
Zone
for daytime and nighttime, each.
•
Actions
: Specify which actions to take when
motion is detected.
- Record : Specify which cameras to begin linked
recording on when an event occurs. If the
schedule is set to Event or Time & Event mode,
the selected cameras will begin linked recording
when an event occurs.
-
Alarm-Out
: Designate event-triggered alarm-out
channels and beeps.
- Notify : Configure to be notified of events by
Mail, LAN1 through 5, SNS, Push, and/or Alert
Window.
- PTZ : Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must
be registered on the remote program.
• Motion Ignoring Time : The system does not
produce event log entries or issues remote
notifications regarding motion detected during the
specified time following the initial motion detection.
Set a value between 1 sec and 5 secs or choose
Never.
Motion Ignoring Time does not affect motion
detection recording.
•
Daytime Setup
: Specify when daytime starts
and ends. Adjust the time frame in 15-minute
increments. Times outside the specified range will
be assumed as nighttime by the system.
Trip Zone
• No. : Select which cameras to apply Trip Zone to.
• Sensitivity : Set daytime and nighttime sensitivity
settings between 1 (Low) and 5 (High).