Direct IP XR408, Operation Manual

Page: 42 / 86

Part 3 - Configuration
42
Types of configuration options shown vary
depending on the PTZ functions supported by the
camera.
1 2 3 4
5
6
7
8
9
0
Numbers shown below Preset, Scan, Pattern,
and Tour indicate the numbers of configured
functions.
1
Preset
• Use the buttons below to choose a preset
position.
- Directional Buttons ( ):
Used to tilt and pan the camera.
-
Zoom
( ): Zoom in and out.
- Focus ( ): Adjust camera focus to far
or near.
- Speed : Specify the camera's panning and
tilting speed.
• Set : Choose a preset number and then enter a
name. This saves the current preset under the
specified preset number and name.
• Go to : Select a preset from the list and then
click Go to to move the camera to the selected
preset position.
• Edit : Used to change the selected preset's
name.
•
Remove
: Used to remove the selected preset.
2
Scan
Used to set up a profile for moving the camera
between two points. At least two presets must be
available in order to use the scan feature.
•
Set
: Used to set up a scan profile.
- Name : Enter a name for the scan profile.
- Start/Stop : Specify which presets to use as
start and stop points.
-
Dwell Time (sec.)
: Specify how long the
camera will dwell at start and stop positions.
- Speed/Direction : Specify scanning speed
and direction.
• Test : Select a scan profile and then click Test to
test it.
• Edit : Used to edit the selected scan profile.
• Remove : Used to remove the selected scan
profile.