3 OF 6
IG051418-1.0
ETERNALUX
™
LED Light Bar
INSTALLATION GUIDE
ETERNALUX
™
LED LIGHT BAR
INSTALLATION GUIDE
TROUBLESHOOTING
TOOLS & RESOURCES
ETERNALUX
™
LED LIGHT BAR SPECIFICATION SHEET
For full specifications.
Shift in
brightness
and/or kelvin
• Ensure an appropriate gauge of
wire is installed between strip light
and LED driver.
See VOLTAGE
DROP CHARTS.
Some LEDs
are not
functional
• Ensure strip light has not been bent
excessively, which could damage
circuitry.
Lights are
flickering
• Ensure a compatible driver and/or
dimming control is installed. Check
for loose connections.
Lights are
turning on/off
repeatedly
• Ensure driver is not overloaded. An
overloaded driver will trip the internal
auto-reset (of driver) repeatedly,
turning the system on/off.
4
INSTALLATION (CONT.)
MOUNT ETERNALUX
™
LED LIGHT BAR
Screw mounting clip to surface
4.1
Place ETERNALUX
™
Strip Light into mounting clip
4.2
5
TURN POWER ON AT CIRCUIT BREAKER
6
ATTACH DRIVER AND LIGHTING
CONTROL.
Verify a compatible driver is installed. Utilize
applicable wiring when installing outdoors. (Use of
wet location-rated junction box recommended)
*Note: 3M VHB adhesive tape included with ETERNALUX
™
LED Light
Bar is intended for indoor installation only. Refer to
INSTALLATION
OPTIONS
on page 4 for further details.
