Dimplex M Flex Air, Installation And Operating Instruction

Page: 32 / 40

30 DOK4x HOIAO FxDEN · FD 0001 www.glendimplex.de
English Air-to-water heat pump M Flex
Information requirements for heat pump space heaters and heat pump combination heaters
Item Symbol Value Unit Item Symbol Value Unit
Tj = - 7°C
P dh
8,0 kW Tj = - 7°C
COP d
2,36 -
Tj = + 2°C
P dh
5,6 kW Tj = + 2°C
COP d
3,41 -
Tj = + 7°C
P dh
6,6 kW Tj = + 7°C
COP d
4,28 -
Tj = + 12°C
P dh
7,7 kW Tj = + 12°C
COP d
5,35 -
Tj = bivalent temperature
P dh
9,4 kW Tj = bivalent temperature
COP d
2,10 -
Tj = operation limit temperature
P dh
9,4 kW Tj = operation limit temperature
COP d
2,10 -
For air-to-water heat pumps For air-to-water heat pumps:
Tj = -15°C (if TOL < -20°C)
P dh
- kW Tj = -15°C (if TOL < -20°C)
COP d
- -
Bivalent temperature
T
biv
-10 °C
For air-to-water heat pumps:
Operation limit temperature
TOL -10 °C
Cycling interval capacity for heating
P cych
- kW Cycling interval efficiency
COP cyc
- -
Degradation co-efficient (**) C dh 0,99 -
Heating water operating limit
temperature
WTOL 60 °C
Power consumption in modes other than active mode Supplementary heater
Off mode
P
OFF
0,025 kW Rated heat output (*) P sup 0 kW
Thermostat-off mode
P
TO
0,026 kW Type of energy input eletrical
Standby mode
P
SB
0,026
kW
Crankcase heater mode P
CK
0,000
kW
Other items
Capacity control variable - 3800 m³ /h
Sound power level, indoors/ outdoors
L
WA
45/55 dB - -- m³ /h
Emissions of nitrogen oxides
NO
x
- mg/kWh
Declared load profile - Water heating energy efficiency
η
wh
- %
Daily electricity consumption Q
elec
- kWh Daily fuel consumption Q
fuel
- kWh
Contact details
(**) If C dh is not determined by measurement nthen the default degradation is C dh = 0,9
(--) not applicable
For air-to-water heat pumps: Rated
air flow rate, outdoors
For water-/brine-to-water heat
pumps: Rated brine or water flow
rate, outdoor heat exchanger
Declared capacity for heating foer part load at indoor temperature 20°C and
outdoor temperature T
j
Declared coefficient of performance or primary energy ratio for part load at
indoor temperature 20 °C and outdoor temperature T
j
For heat pump combination heater:
Glen Dimplex Deutschland GmbH, Am Goldenen Feld 18, 95326 Kulmbach
(*) For heat pump space heaters and heat pump combination heaters, the rated output P rated is equal to the design load for heating P designh , and the rated
heat output of a supplementary capacity for heating sup( Tj ).
133 %
Heat pump combination heater no
Parameters shall be declared for medium-temperature application, except for low-temperature heat pumps. For low- temperature heat pumps, parameters
shall be declared for low-temperature application.
Rated heat output (*)
Prated 9 kW
Seasonal space heating energy
efficiency
η
s
Parameters shall be declared for average climate conditions:
Brine-to-water heat pump no
Low-temperature heat pump no
Equipped with a supplementary heater yes
Model Mflex 0916
Air-to-water heat pump yes
Water-to-water heat pump no