Dimplex LAK 14IMR, Installation And Operating Instructions Manual

Page: 26 / 80

EN-4 452162.66.09 · FD 9512 www.dimplex.de
English
LAW 6IMR - LAW 14ITR
4 Outdoor unit
4.1 Installation
 It is advisable to install the outdoor unit close to a wall, on a
foundation separate from the building with a minimum clear-
ance of 0.3 m on the intake side (Fig.4.1 + Fig.4.2).
 If a canopy is mounted to protect from direct sunlight, rain or
snow it must not impede the heat exchange of the device.
 In the case of a free-standing installation, the foundation is
to be connected on the intake side, flush with the device.
This will prevent snow from building up between the founda-
tion and the evaporator.
 The minimum clearances (Fig.4.1) indicated must be ad-
hered to.
 When selecting an installation location, it should be ensured
where possible that persons are not going to be inconven-
ienced by the circulation of warm/cold air or by noise emis-
sions.
 The condensate tray offers various options for the conden-
sate drain. In warmer regions, the condensate can drain
from the device freely. In regions with longer periods of frost,
a controlled condensate drain is required.
Fig. 4.1
Fig. 4.2
Fig. 4.3
Installation on wall brackets is not advisable, as this frequently
leads to noise problems.
If this type of installation is used, observe the following instruc-
tions:
 Fit rubber buffers
 Take the weight of the outdoor unit into account
 Ensure that the wall bracket is no higher than 1 m above the
ground
 Ensure that minimum clearances are adhered to
Fig. 4.4
0,2 m
0,3 m
Heat pump
Condensate drain
Frost line
0,3 m
0,2 m
> 5%
Heat pump
Condensate drain
Frost line
P
P
P
P
P
P
P
P
P
P