It is recommended to ground the generator before operating it for the first time. Before starting the device,
remember that the total power of the connected power consumers should not exceed the nominal power
of the generator.
TERMS OF USE
OF INVERTER GENERATOR
4
GENERATOR OPERATION
5
To avoid electric shock due to poor-quality electrical
appliances or improper use of electricity, the generator
must be earthed using a high-quality insulated conductor.
IMPORTANT!
Make sure that the control panel, the blinds and the
underside of the inverter are well cooled and protected
against the ingress of small solids, dirt, and water.
Improper operation of the cooler can cause damage to
the motor, inverter or alternator.
IMPORTANT!
DC FUSE
The DC protector automatically switches to “OFF” when the current of the operating electrical device is
higher than the rated current. To use this equipment again, turn on the DC fuse again by pressing the “ON”
button.
OIL LEVEL INDICATOR
When the oil level falls below the level required for operation, the oil level indicator lights up, and then the
engine stops automatically. The engine will not start until oil is added.
AC INDICATOR
When the generator is running and producing electricity, the AC indicator light is on.
If the DC fuse turns off, reduce the load of the connected
electrical device. If the DC protector turns off again, stop
operation and contact your nearest Könner & Söhnen
service center.
IMPORTANT!
OVERLOAD INDICATOR
The overload indicator lights up when the connected generator is overloaded, the inverter control unit
overheats or the AC output voltage rises.
If the overload indicator goes on, the engine will continue to operate, but the generator will no longer
produce electricity. In this case, you must perform the following steps:
1. Turn off all connected electrical appliances and stop the engine.
2. Reduce the total power of the connected devices until the nominal power of the generator is reached.
3. Check if the vent grid is clogged. Remove excess dirt or debris, if any.
4. After checking, start the engine.
The overload indicator may light up within several
seconds after start-up or when connecting electrical
devices requiring a high starting current, such as a
compressor or voltage indicator. However, this is not a
malfunction.
IMPORTANT!
www.ks-power.de/en
|
21
Summary of Contents for Konner & Sohnen 4260405363322
Page 16: ......
