RECOMMENDED OILS
10
The manufacturer shall not be liable for any damage
caused by failure to perform maintenance work.
IMPORTANT!
- If the generator often operates at high temperature or high load, the oil should be replaced every 25
operating hours.
- If the engine often runs in dusty or other harsh conditions, clean the air filter every 10 operating hours.
- If you missed the maintenance time, perform it as soon as possible to save the generator engine.
TECHNICAL MAINTENANCE WORKS
Unit
Action
At each start
First month
or 20 operating
hours
Every 3 months or 50 operating
hours
Every 6 months or 100 operating
hours
Every year
or 300 operating
hours
Motor oil
Level check
Replacement
Air filter
Cleaning
Replacement
Spark plug
Cleaning
Replacement
Fuel tank
Level check
Cleaning
Fuel filter
Check (clean out)
Upon oil level decrease it is necessary to add the required quantity in order to provide the correct generator
operation. It is necessary to check the oil levels according to technical maintanance schedule.The detailed
description of oil filling and draining can be found in the full version of the manual.
Use oils designed for four-stroke cycle vehicle engines
SAE10W-30, SAE10W-40. Motor oils with other viscosity
levels, may be used only if the average air temperature
in your region does not exceed the limits of the
temperature range, specified in the table.
0
0
C
10W-30, 10W-40
40
30
20
10
-10
-20
AIR FILTER TECHNICAL MAINTENANCE
11
Air filter cleaning is to be performed each 50 hours of the generator operation (every 10 hours in unusually
dusty conditions).
CLEANING THE FILTER:
1. Open the clips on the upper cap of the air filter.
2. Remove the sponge filtering element.
3. Remove all dirt deposits inside the hollow case
of the air filter.
4. Thoroughly wash the filtering element in
warmsoapy water.
5. Dry the sponge filter.
6. Dry filtering element is to be moistened by
machine oil and excess oil is to be squeezed out.
www.ks-power.de/en
|
27
Summary of Contents for Konner & Sohnen 4260405363322
Page 16: ......