Chapter 2: Unit Installation
tftp
,
ftp
, or
http
. The Gateway Series appliance will request a
configuration database with the filename of xxxxxxxxxxxx.tgz, where
xxxxxxxxxxxx is the unit’s first MAC address, from the configuration
server. The MAC addresses of the Gateway Series appliance are
printed on a label on the back of the unit. FTP and HTTP normally do
not require a username and password.
The
Configuration Server
options for the G100 and G200 models are
specified below.
Reload Remote Config on Reboot
- Leaving this option enabled will
allow the Gateway Series appliance to request that its configuration be
reloaded from a configuration server on every reboot.
Note:
If this feature will not be used, it is recommended that it be
disabled.
Get Config Server from Option 66 via DHCP
- If
Obtain an IP
Address via DHCP
is enabled and the DHCP server specifies the path
and configuration database file on the configuration server using
Option 66, this feature may be enabled for all Gateway Series configu-
ration settings to be automatically configured using a configuration
server. The
Reload Remote Config on Reboot
option must be
enabled in order to activate this feature. Refer to the note on
page 38
for proper syntax when specifying the path and configuration database
file.
Configuration Server
- If
Obtain an IP Address via DHCP
is
enabled and
Get Config Server from Option 66 via DHCP
is dis-
abled, the path to the configuration server may be statically defined
using this option. The
Reload Remote Config on Reboot
option must
be enabled in order to activate this feature. Refer to the note on
page 38
for proper syntax when specifying the path and configuration
database file.
Digium, Inc.
Page 39